How to Resole Boots – Replacing the soles of work boots is one important maintenance that is often overlooked by many workers.

Work boots that are used daily experience constant pressure and friction, can wear out the soles quickly. That’s why you need to know how to replace work boot soles the right way.

So, with that being said, in this article, we will discuss in detail how to resole a work boots and the reasons why this step is very important to do regularly.

How to Resole a Boots

1. Prepare the Necessary Tools and Equipments

Before starting the work boot sole replacement process, make sure you have prepared all the necessary tools and materials to ensure the job runs smoothly.

First of all, prepare replacement insoles that match the size and type of your work boots. Next, make sure you have special glue for shoes that can stick firmly and durably.

Also, provide a knife or pry tool to carefully remove the old insoles without damaging the shoes. Finally, prepare a cloth or tissue to clean up the remaining glue and keep the work area clean.

2. Take Off the Old Soles

The first step in the process of replacing work boot soles is to carefully remove the old soles.

To start, use a knife or pry tool to gently open the edge of the sole. Make sure to work gently and slowly so as not to damage other parts of the shoe.

If the old soles are very firmly attached and difficult to remove, you can use a little heat to help with this process.

Try using a hair dryer to warm up the glue area, so that the glue becomes softer and easier to remove without damaging the shoe.

3. Clean the Soles Area

Once the old sole has been successfully removed, the next step is to clean the surface of the shoe from any remaining glue or dirt that may be left behind.

To do this, use a cloth or tissue that has been moistened with a little water or rubbing alcohol and rub it gently on the areas affected by the glue or dirt to remove it thoroughly.

This cleaning process is important to ensure that the surface of the shoe is completely clear of any glue residue that may interfere with the adhesive process of the new sole later.

After cleaning, ensure that the shoe surface is completely dry before proceeding to the next step as moisture can reduce the adhesion of the glue and affect the final result of the new sole installation

4. Apply Glue to New Soles

Apply the special shoe glue evenly on the surface of the new sole and also on the surface of the shoe to be affixed.

Make sure to spread the glue well, so that no part is missed and the result is strong and durable.

An even application of glue will ensure an optimal bond between the sole and the shoe, providing protection and comfort during use.

Also Read: “How to Repair Your Work Boots“

5. Apply New Soles with Pressure

The next step is to attach the new insoles to the shoes. Carefully position the sole in the right place and press firmly so that the sole sticks well to the surface of the shoe.

Make sure that all parts of the sole are neatly attached so that there are no gaps that can interfere with the performance of the shoe.

To ensure that the sole stays in position while the glue dries, you can use a heavy object or a pair of tweezers to hold it in place.

Leave the soles wedged for a few hours to allow the glue to completely dry and harden, providing a strong bond.

This way, your safety shoes will be ready to use again with optimal performance and good durability.

And that’s that! A guide on how to resole boots! Replacing the soles of safety shoes is an important step you should take if your boots are worn out to maintain your comfort and safety in the workplace.

Through how to replace the soles of safety shoes, you can replace the soles easily and ensure that the shoes remain in the best condition.

Always check the condition of your safety shoe soles and don’t hesitate to replace them if they show any signs of wear.