How to Change Car Tire: A Step-By-Step Guide

Learning how to change car tire is an important skill to have in case of an emergency.

Imagine you’re relaxing and enjoying a trip in your favorite vehicle and suddenly you have a flat tire.

It must be annoying, right? But worry not, by following our article on this one, you no longer need to worry because you can use the knowledge here to know how to change car tire.

Let’s take a look together!

How to Change Car Tire

1. Pull Over to a Safe Location

When you realize that your car has a flat tire, avoid immediately hitting the brakes and changing direction suddenly. 

This can cause a traffic accident, especially when you are traveling on the highway. It’s better to keep going slowly and turn on the hazard lights. 

The goal is that the car behind you can still be careful when one day you stop. Then, find a place to pull over on the road. 

Make sure the road surface is flat and straight so that you can easily change your tires. Also, avoid stopping near bends because the visibility of other drivers is more limited.

After pulling over, you can put up a warning sign so that other drivers can be more careful.

2. Prepare the Tools

There are several tools you need to change a tire: a jack, a wrench, and of course, a spare tire is a mandatory tool for changing a car tire. 

Therefore, make sure these three items are always available in the car. Other than that, additional equipment that you can prepare are a flashlight, gloves, manual book and tool kit to make it easier for you to change your tire.

3. Lift Your Car

After that, you need to lift the car using a jack. To do this, place the jack at the bottom of the car.

Make sure the jack is level to the ground at all times and avoid bumpy ground to ensure a solid and rigid jacks. 

The jack mounting points are usually located around the wheels of the car, which have been specially designed by the car manufacturer. 

Just in case the jack can’t support the weight of the car, place a spare tire underneath it. Make sure you use the car jack until the wheel you want to replace is lifted off the ground and can be pulled out.

3. Loosen the Bolts

Now, you need tools to loosen the tire bolts. The tool you need is a wheel wrench. The way to loosen the tire bolts is quite easy. You just need to turn the wheel bolt counterclockwise. 

4. Remove the Flat Tire

When the jack has successfully supported the car and the flat tire has room to pull, take the wheel wrench again and loosen the tire bolts until they are completely removed.

Make sure you keep the bolts in a safe place so you don’t have trouble finding them when you need to reinstall them. Then, pull the problem tire all the way out.

5. Make Sure The Spare Tire Is In a Great Condition

Before installing the spare tire, make sure that the spare tire is in a great condition and having a proper air pressure,

To install it, simply reverse the steps that we’ve covered above, just put your tire on your car and slowly tighten the bolts one by one.

One thing to notice, make sure that the bolts are safely tightened to prevent any unwanted accidents.

6. Lower Your Car Slowly

After those steps are done, you can slowly lower your car and release it from the jacks, and pull out the jacks.

Check the bolts for the last time is recommended to ensure a secure and tight connection. 

So there you have it! A guide on how to change car tire that we’ve summarized just for you!